For a sales quote, meeting request, evaluation unit, or other sales question, please fill in the form below:


Terms of Use | Privacy Policy
HITEK POWER® Series IP100
Photo of XS Series Power Supply
   

Ion Pump Power Supplies

The IP100 is designed to drive a vacuum chamber ion pump, where a vacuum in the region of 1x10E-11 Torr is required.
Features Typical Applications
  • 90V to 265V AC Operation
  • 115W Output Power
  • Positive or negative polarity
  • Compact size
  • Lightweight – only 1.6kg
  • Protection against output short circuit
  • Current monitor
  • Safety interlock
  • EU RoHS compliant to 2011/65/EU
  • Ion pumps
  • Mass spectrometers
  • Scanning electron microscopes
  • High integrity vacuum systems
Specifications
Output power 115W output at 240V input.
Output voltage 5kV or 7kV depending on model.
Output current 800mA max.
Input voltage 90V to 265V AC
Input current 2A max.
Polarity Postive or negative to order
Output ripple Less than 30V peak to peak
Operation A mains ON/OFF switch, ENABLED indicator lamp and fuse are provided on the front panel.  HV Enable and a Current Monitor are provided via a 9-way D-type connector situated on the rear panel.  A current monitor is also provided via 4mm banana sockets.
Current monitors Fibre optic transmitter: A series of light pulses, where the frequency is directly proportional to the load current over the range 1μA to 1 mA.  1mA load gives 30kHz. (Frequency (Hz) = load current x 30E6) ±5%.)
4mm sockets or 9-way D-type (pins 3 or 4): A voltage directly proportional to the load current over the range 1μA to 2mA. (1mA load = 4.7V monitor ±5%.)
Remote enable The presence of a 24V supply fed remotely enables the supply.
Operating temperature 10°C to 40°C
Altitude Sea level to 2000 metres (6500 feet).
Humidity 80%
Assembly The unit incorporates an air insulated HV assembly to achieve a total weight of less than 1.6kg (3.5lb)
Protection Robust design ensures that the power supply is immune to output short circuit
Safety An interlock is provided which disables the power supply when the cover is removed.  The series IP100 meets the requirements of the Low Voltage Directive (LVD) 2006/95/EC by complying with BS EN61010 when it is installed as a component part of compliant equipment.  It is CE marked accordingly.
RoHS The Series IP100 meets the requirements of EU Directive 2002/95/EC on the Restriction of use of Certain Hazardous Substances in electrical and electronic equipment (RoHS).


Accuracy of specifications in unlocked documents cannot be guaranteed. Please contact your AE representative to confirm specifications.